Investigate an Unhealthy asset in Uptime
Find a communication gap on a selected day and check when the asset last reported.
Overview
Use Uptime to find an asset that went quiet for longer than its communication threshold on a selected day. Then check when it last reported and gather the details you need to follow up.
Prerequisites
Make sure you can open Uptime and the asset’s Snapshot. If you’re checking a reported incident, have the asset name and the approximate time it occurred.
Step-by-step instructions
- Find the affected day. Open Assets, select Uptime, and open Overview. Choose a date range. On the Asset Health chart, select a day with an Unhealthy result and confirm the UTC date above the daily table.
- Find and read the affected asset. Select the Unhealthy card. If you know the asset name, use Search assets. Confirm the row’s Status before reading its values.
Read across the row from Status to Threshold (h) and Last Contact. This demo asset had reported before.
- Threshold (h) is the length of time the asset can go without checking in before Uptime flags a gap.
- Last Contact shows the recorded contact time in the row. Hours Since Contact gives the elapsed time shown by Uptime. Open Columns and enable Max Gap (h) if you need that additional value from the daily table.
- Check whether the asset has reported since. Select the asset name to open its Snapshot. Compare the asset’s Last Seen with the earlier date you investigated. If you need to check a specific linked device, open Devices. A later contact tells you it reported again. The earlier Uptime result still describes the selected day.
- Share what you found if the gap needs investigation. Give your administrator or Perspio Support the asset name, the selected UTC date, Status, Threshold (h), Last Contact, and any later Last Seen you found.
Tips & troubleshooting
- If the date looks different from an incident log, compare the local time with the UTC day in Uptime.
- If the asset is missing, clear Search assets, select Assets to show all statuses, and check the global Filter. See the Uptime Module Overview.
- If you need device-level contact information, see Device Health.